STEP 4. INSTALL THE EXTERIOR DRIP CAP
4A -
It is critical to place the Drip Cap on top of the
Shield Track as seen in the image.
Begin by making guide marks
1-9/16” above the window.
4B -
Secure the drip cap on the right side with 1 pan
head screw. Then, make sure the drip cap is level and
rests on the marks. If so, secure with another pan head
screw.
Use 3 evenly spaced pan head screws to finish securing
the Drip Cap.
STEP 5. INSTALL THE DRAW CORD LOCK
5A
-Pull the shield up and down a few times to center the
cord in the window. Once you’ve found the center, let the
shield down. Then measure 14” down from the center and
mark the position. Position the Speed Cinch® over the
mark, and place the tube in a vertical position. The notch
should be at the bottom. Secure the Speed Cinch® with
two #8 x 1”screws. Run cord through the tube.
STEP 7. INSTALL THE INTERIOR GLASS
AND FASTENERS
7A -
Hold the glass and hinge over the window
opening. Measure about 7/8” from the top of the
window cutout and make a mark. Then measure
about 7/8” from the left side of the window cutout,
making marks at both the top and bottom.
7B -
Line up your glass window and place 3 washer
head screws in the metal hinge.
7C -
Place 2 window latches on the right side of
the window. Measure 4” down from the top of
the glass and 4” up from the bottom of the glass.
7D -
Use washer head screws to secure
window latches.
11/2018
Archery Window - Silent Shadow Window System
SUMMIT OUTDOORS, LLC
Fort Wayne, IN 46804 • Toll Free: 1-888-446-4868 Fax: 260-483-2070
www.shadowhunterblinds.com
5B -
Run the cord through the speed cinch tube. Then
thread the cord throught the rubber shield stop. Now
tie a knot at the end of the cord. You may need to
adjust the knot to make sure the shield is at or just
below the window.
