STEP 1. PREPARING YOUR BLIND
Mark the intended position of your window
using the measurements indicated here.
Cut the window frame.
STEP 2. INSTALL THE EXTERIOR
SHIELD TRACKS
2A
- On each of the 24-1/2” sides, measure over 1-3/4”
at the top and bottom corners. Be sure to mark all
four spots.
2B -
Using the marks as a guide, position the first
exterior shield track along one side of the window
opening. Raise the channel about 1/8” above the top of
the window. Use 1 pan head screw to hold the exterior
track in place.
Repeat step 2B on the opposite side.
2C -
Using 2 pan head screws, install the top half
of the shield track (the short piece). Then, install the
bottom half of the shield track, with about 1” of the
bottom track overlapping the top track. The total length
of the combined shield tracks is 46-1/4”. Secure each
combined track with a total of 6 pan head screws.
(Archery window instructions continue on the other side)
Screws & hardware included
for one window systems:
[16] #8 x 1" Washer Head Screws
Use 3 screws per interior glass track.
[30] #8 x 3/4" Pan Head Screws
Use 6 screws per exterior shield track.
Use 3 screws per drip cap, evenly spaced.
[2] Rubber Window Shield Stops
[2] Interior Hinged Glass Panel
[2] Window Shield with Draw Cord
[2] Drip Cap
[4] Exterior Shield Tracks
[4] Exterior Shield Tracks
Extensions
[2] Speed Cinch®
[6] Window Latches
Speed Cinch®
Exterior
Window Shield
with Draw Cord
Interior Hinged Glass Panel
Exterior Shield Track
Exterior Drip Cap
#8 x1” Washer
Head Screws
Tools Needed:
Cordless Drill • Square Drive Bit • Tape Measure • Saw • Staple Gun
Exterior Shield Track Extensions
Window
Latch
Rubber Window
Shield Stop
STEP 3. INSTALL THE EXTERIOR SHIELD
Drop the exterior shield into place behind the exterior
shield tracks. The cord hole should be on the bottom
of the shield.
8" WIDE
24-1/2" HIGH
27" from floor to
bottom of window
