CHANGING MODES
Press the button to cycle through lighting effects:
1.
Single Color Fade: The selected color will fade off
and on.
2.
Multi-Color Fade: Fades up and down and cycles
between colors depending on selected color
sequence.
a.
Blue / White
b.
Red / Green / Blue / White
c.
All Colors
3.
Multi-Color Change: Same color sequences as
Multi-Color Fade, but maintains brightness on a color
before fading to the next color.
4.
Strobe / Flash: Flashes a specified color at a
specified rate.
a.
To adjust the color of a mode, use the or
buttons.
b.
To adjust the rate, press and hold the
button and use either of the or buttons at
the same time.
ADJUST BRIGHTNESS
Select the desired zone(s) and use the buttons.
E.g. Press then turns zone 3 brightness
down by 2 steps.
CHANGING COLORS
Select the desired zone(s) and press a color (white,
red, green or blue) or press or to advance to the
previous/next color in the Color Index (see Color Index
Cycle below).
E.g. Press then turns all zones red.
COLOR INDEX CYCLE
3
ALL
MODE
MODE
MUSIC SYNC
Select the desired zone(s) and press the button
to activate music sync.
There are 3 different music sync modes:
1.
Full Color Frequency:
Different frequency ranges
from the music drive the intensity of different colors.
2.
Single Color Amplitude:
Brightness of lights is driven
by different intensity of the music. In this use the
or buttons to select a single color.
3.
Multi-Color Amplitude:
Similar to Single Color
Amplitude, but colors are rotating continuously.
OPTIMIZING MUSIC SYNC
1.
Turn music to typical listening volume, and press
PAUSE on your stereo system. This will provide the
lighting controller with an input signal representative
of the audio system background noise.
2.
Press and hold while repeatedly clicking the
button until the lights start blinking, then click
button one click at a time until the lights do not blink
or flicker - this sets the system sensitivity to just
above the audio systems noise floor.
3.
While still holding press PLAY on your stereo
system, now adjust or to set the signal
averaging. This adjusts how quickly the sound
responds to the music.
ADJUST BACKLIGHTS OF CONTROLLER
Press and hold the button and use either of the
or buttons until the desired brightness is
achieved.
SAVING SETTINGS
Once everything is configured as you wish press the
button to save the your settings.
SYNC
SYNC
SYNC
Cool White
Neutral White
Warm White
Pink
Purple
Red
Orange
Red Orange
Gold
Yellow
Green
Lime
Olive
Aqua
Blue
Sky
Blue
Indigo
Orchid
Purple
Magenta
ST
AR
T
SCM-ZC-KIT
OPERATION MANUAL
ALL
OFF
Designed & Manufactured
in Clearwater, FL
© 2021 Shadow-Caster
®
LED Lighting, All Rights Reserved
5
