Measure inward from the centerline of the outside track 5’-4”.
Place the
Mid-beam Bracket
on the cross beam at this distance.
This location should be directly across from the End Mounting
Bracket on the house (step 1.) Secure the
Mid-beam Bracket
in
place with four 7/8” Tapping Screws (A).
Step 14
Assemble
Mid-beam Bracket
Header beam
Mid-beam Bracket
5’-4” to centerline
of outside track. See CAD
5’-4” to centerline
of outside track. See CAD
Mounting holes
Insert the arm of the
Extender
and the arm of the
Mid-beam
Bracket
into the
Middle Projection Beam
. Secure the beam by
inserting two 7/8” Tapping Screws (A) into the beam at each end.
Step 15
Connect
Middle Projection Beam
Mid-beam
Bracket
Middle
Projection Beam
Extender
End Mounting
Bracket
Header
Beam
ShadeTree Cool Living, LLC
— For questions or assistance call
800-894-3801
.
8
The Bungalow
ShadeTree
®
Canopy Systems
Assembly Instructions
Lift the
Column Base
and use something to prop it up while you
position the
Base Plate(s)
. Once in position pre-drill the holes and
then secure the
Base Plate(s)
with the screws. Then put the
Column Base
back into it’s place at the bottom of the column.
Step 16
Connect
Column Base Plates
Insert the arm on the
Corner Bracket
of the attached
Projection
Beam/Column Assembly
into the end of the
Header Beam
.
Attach the other
Projection Beam/Column Assembly
to the
End
Mounting Bracket
on the wall.
To secure the
Header Beam
, screw two 7/8” Tapping Screws
(A) through the pre-drilled holes on the top of the
Header
Beam
into the
Corner Brackets
at both corners.
Step 12
Connect
Column Assemblies
Header
Beam
Projection
Beam
Column
Assembly
Step 13
Check to make sure the
Assembled Outer
Frame
is
SQUARE
Measure the distance from one
Projection Beam/Column
Assembly
to the opposite outside
End
Mounting Bracket
on the
house. Then measure the distance from other
Projection
Beam/Column Assembly
to the opposite outside
End
Mounting
Bracket
on the house. Both measurements must be the same
for the system to be considered square. You must make any
necessary adjustments to ensure that it is square before
permanently anchoring the
Columns
.
