PAGE 9
PAGE 8
STARTING THE ENGINE
6. Pull the recoil starter grip lightly until-resistance is felt, then
pull it briskly. Do not allow the recoil starter grip to snap back
against the engine. Return it gently to prevent damage to the
starter.
7. If the choke lever was moved to the CLOSED position to start
the engine, gradually move it to the OPEN position as the en-
gine warms up.
SETTING THE ENGINE SPEED
8. After starting the engine, move the throttle lever to the FAST
position for self-priming, and check pump output. Pump output
is controlled by adjusting engine speed. Moving the throttle
lever in the FAST direction will increase pump output, and mov-
ing the throttle lever in the SLOW direction will decrease pump
output.
9. To stop the engine in an emergency, simply turn the ignition
switch to the OFF position. Under normal conditions, use the
following procedure.
a. Move the throttle lever to the SLOW position.
b. Turn the ignition switch to the OFF position.
c. Turn the fuel valve lever to the OFF position.
After use, remove the pump drain plug, and drain the pump
chamber. Remove the filler cap, and flush the pump chamber
with clean, fresh water. Allow the water to drain from the pump
chamber, then re-install the filler cap and drain plug.
WWW.SGS-ENGINEERING.COM
