PAGE 9
PAGE 8
CARE & MAINTENANCE
The tool should be lubricated before each use with air tool oil (not in-
cluded). Air tool oil is available from SGS Engineering. During continuous
operation, the tool should be oiled every 1 to 2 hours. This may be done
using an in-line oiler or manually.
1. Disconnect the tool from air supply. (See Figure 6)
2. Place a few drops of air tool oil into the air inlet. (See Figure 7)
Avoid the misuse of thicker oil which may lead to the reduced
performance or malfunction.
3. Connect the tool to the air supply. Run the tool without load for a
few seconds to distribute the oil through the tool. Any excess oil
may be propelled from the air exhaust area so point the tool in a
safe direction.
4. After operating the tool and before storing the tool, disconnect
the air hose and place 4 or 5 drops of air tool oil into the air inlet,
then re-connect the air hose and run the tool to evenly distribute
the oil throughout the tool for approximately 30 seconds. This will
prolong the tool life.
5. Avoid storing the tool in a humid environment.
OPERATING INSTRUCTIONS
How to install/tighten threaded fasteners.
1. Push the F/R valve knob (D) backward. Press the trigger (C).
2. Then the tool anvil (B) runs clockwise. (See Figure 1-a)
How to remove/loosen threaded fasteners
1. Push the F/R valve knob (D) forward. Press the trigger (C).
2. Then the tool anvil (B) runs counter-clockwise. (See Figure 2-a)
3. This tool features a power regulator valve. Rotate the F/R valve
knob (D) until desired output is achieved. The settings 1, 2, 3 are
only for reference and do not denote a specific power output.
“Setting 1” is the least amount of power while “Setting 3” is
the most amount of power. Rotate the F/R valve knob (D) either
clockwise or counter-clockwise having the triangle mark or hollow
line on the knob (D) pointing at any setting to get the desired
power. (See Figure 3-a & Figure 3-b)
FIGURE 1
FIGURE 2
FIGURE 3
FIGURE 4
OPERATING INSTRUCTIONS
FIGURE 5
FIGURE 6
FIGURE 1-a
FIGURE 2-a
FIGURE 3-a
FIGURE 3-b
WWW.SGS-ENGINEERING.COM