PAGE 9
PAGE 8
CARE & MAINTENANCE
The tool should be lubricated daily (or before each use) with air tool oil (not in-
cluded). Air tool oil is available from SGS Engineering. Do not use detergent oil.
During continuous operation, the tool should be oiled every 1 to 2 hours. This may
be done using an in-line oiler or manually. If done manually, proceed as follows:
1. Disconnect the tool from air supply. (See Figure 6)
2. Place a few drops of air tool oil into the air inlet. (See Figure 7) Avoid the misuse
of thicker oil which may lead to the reduced performance or malfunction.
3. Connect the tool to the air supply. Run the tool without load for a few seconds
to distribute the oil through the tool. Any excess oil may be propelled from the air
exhaust area so point the tool in a safe direction.
4. After operating the tool and before storing the tool, disconnect the air hose and
place 4 or 5 drops of air tool oil into the air inlet, then re-connect the air hose and
run the tool to evenly distribute the oil throughout the tool for approximately 30
seconds. This will prolong the tool life.
5. Avoid storing the tool in a humid environment which promotes rusting of internal
mechanisms. Always oil the tool before storage.
OPERATING INSTRUCTIONS
1. How to install/tighten threaded fasteners
Push the F/R valve knob (D) backward. Press the trigger (C).
Then the tool anvil (B) runs clockwise. (See Figure 1-a)
2. How to remove/loosen threaded fasteners
Push the F/R valve knob (D) forward. Press the trigger (C).
Then the tool anvil (B) runs counter-clockwise. (See Figure 2-a)
This tool features a power regulator valve. Rotate the F/R valve knob (D) until
desired output is achieved. The settings 1, 2, 3 are only for reference and do
not denote a specific power output. “Setting 1” is the least amount of power
while “Setting 3” is the most amount of power. Rotate the F/R valve knob (D)
either clockwiseor counter-clockwise having the triangle mark or hollow line on
the knob (D) pointing at any setting to get the desired power. (See Figure 3-a
& Figure 3-b)
FIGURE 1
FIGURE 2
FIGURE 3
FIGURE 6
FIGURE 5
FIGURE 4
FIGURE 1-a
FIGURE 2-a
FIGURE 3-a
FIGURE 3-b
WWW.SGS-ENGINEERING.COM