PAGE 27
PAGE 26
MAINTENANCE
REFILLING TRIMMING LINE
For replacement line, use a diameter of 2.4mm (.095in).
The spool is capable for a line upto 6m (20ft) on the 10cm
(4”) head. Avoid using a larger line as it may cut down the
trimming performance. For safety reasons, do not use metal
reinforced line.
1. Pinch the slotted area on the both sides of the spool
housing to unhook the bottom cap.
2. Take out the spool and pull off the old line. Put one end
of new line through the spool holes and pull it until the
length is equal between each part of the line.
3. Wind up the line in the correct direction as indicated on
the spool.
4. Hook each end of the line in the slot on the edge of the
spool, and then put the ends through the eyelets on the
housing. Make sure that the spring and the washers are in
place.
5. While holding the spool against the housing, pull the
line ends to release them from the slot.
6. Line up the slot on the bottom cap with the hook on
the housing, press the cap against the housing until it
clicks.
MAINTENANCE
WWW.SGS-ENGINEERING.COM
CALL FOR ASSISTANCE:
01332 576 850
