5
Product Version 1.0 | Revision D | Released 2023-01-10
BEFORE INSTALLING THIS PRODUCT
Please visit the SGM official website at www.sgmlight.com for the latest version of this user
manual/ safety information leaflet. Due to continuous improvements, the instructions may
change without notice. SGM always recommends the latest available firmware version from
www.sgmlight.com.
EXTERNAL CLEANING AND VISUAL INSPECTION OF THE FIXTURE
All users of the SGM fixtures should regularly clean those parts of the fixture directly exposed
to the elements, such as the external housing and front lenses. Additionally, all owners of the
SGM fixtures must periodically check the external housing of the fixture for structural breaks,
deterioration, cracked lenses, or loose screws. To ensure proper operation, but also to prevent
the risk of potential accidents, do not use the fixture if the lens, housing, or power cables are
damaged. If parts of the fixture appear to be missing, cease use immediately and contact SGM
support.
WIRING AND CONDUIT/ CONTAINMENT
SGM fixtures supplied with power and data cable leads are not intended for installation in
permanently installed conduit or containment. When installing the fixtures in a permanent
installation, ensure cable leads are installed as a service loop to an appropriately rated junction
box using suitable cable strain reliefs/glands. All installed fixtures must be securely mounted,
and service loop appropriately protected for installation location. All electrical wiring and
connections should be completed by a qualified electrician.
SAFETY PRECAUTIONS
When using electrical equipment, basic safety precautions should always be followed includ-
ing the following:
• Do not mount near gas or electric heaters.
• Permanently installed equipment should be mounted in locations and at heights
where it will not be readily subjected to tampering by unauthorized personnel.
• The use of accessory equipment not recommended by the manufacturer may cause an
unsafe condition.
• Do not use this equipment for other than intended use.
• Refer service to qualified personnel or authorized service centers.
• Do not look directly into the beam for long periods of time, when the fixture is on.
• The fixture shall, under no circumstance, be covered with insulating material of any
kind.
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
