TB 220
TM
Turf Brush Owner’s Manual Rev D
Copyright 2015 SGM Industries, LLC
Page 4 of 11
Assembly and Setup
The TB 220
TM
Turf Brush is very straightforward to setup. Very few assembly steps are
required. Follow the instructions below and you will be ready to operate the brush.
Assemble the hitch tube (1) to the frame (36) using the hex bolts and nuts (20 &
17) provided. (Image A) Tighten these fasteners securely.
Attach the unit to the desired tow vehicle. Adjust the position of the hitch
weldment (24), using the two quick-release lynch pins (7), until the hitch tube (1)
is parallel to the ground. (Image B) It is important to perform this setup on a
level and flat surface. The hitch weldment (24) and the hitch tube (1) can both
be positioned in two different orientations to encompass a large range of tow
vehicles.
Connect the actuator control box harness assembly to the brush harness. Route
the cable as needed so it does not become tangled or allowed to catch on
anything during use. The red battery clip should be attached to the positive lug
on the tow vehicle battery, and the black battery clip is connected to the
negative lug.
Check the tires for proper inflation of 14 psi (97 kPa).
The TB 220
TM
Turf Brush comes from the factory with all initial lubrication
already performed. The brushes are set in the lockout position for shipping.
Please see page 5 for information on adjusting brush height.
Image A
Image B
