GB
SGM
Fogger 1000 - Fogger 1500
6
overrides all other control functions and activates maximum output. Press the red POWER ON/OFF
button for continuous output.
Z-50: Wireless remote controller with 6,3 mm jack plug for SGM fog machine models Fogger 1000
and Fogger 1500. A remote operation is possible up to a distance of 50 meters. Keep the red button
pressed for fogging.
Z-10, Z-40, Z-50 REMOTE CONTROLLER
Z-10
Z-40
Z-50
Cable length: 10m
Connector: 6,3 mm jack
Function: On/Off Toggle Switch
Cable length: 10m
Connector: 6,3 mm jack
Function: Timer wih interval and
duration; manual On/Offt
Cable length: wireless, up to 50m
Connector: 6,3 mm jack
Function: wireless ON/Off
8
P
ERFORMANCE
N
OTE
All fog machines develop condensation around the output nozzle. Because this may result in some
moisture accumulation on the surface below the output nozzle, consider this condensation when
installing your unit.
All fog machines may sputter small amounts of fog occasionally during operation and for a minute or
so after being turned off.
All fog machines have a recycling period after long bursts when the machine will shut itself down for
a short period in order to heat up again. During this time no fog can be produced.
9
M
AINTENANCE
Do not allow the fog liquid to become contaminated. Always replace the caps on the fog liquid container
and the fog machine liquid tank immediately after filling. After every 40 hours of continuous operation, it
is recommended to run a cleaning solution composed of 80% distilled water and 20% ACETIC ACID
through the system to prevent the accumulation of particulate matter in the heating element.
The recommended cleaning regimen is as follows:
1.
Empty all fog liquid from the machine. Add cleaning solution to tank. Plug unit in and begin warm up.
2.
Run the unit in a well-ventilated area until the tank is almost empty. Do not allow the pump to run
dry.
3.
Cleaning is now complete. Refill with fog liquid. Run the machine briefly to clear any cleaning solution
from the pump and heater.
4.
Do not operate the fog machine without liquid at any time.
Note:
All fog machines are prone to clogging due to the thick consistency of fog liquid and the high
temperature at which it vaporizes. However, a properly maintained fog machine should provide
years of reliable use.
Clean with a dry cloth only. Store dry.
Cleaning your fog machine regularly will help reduce costly replacement and repair charges.
Interval
Duration
6,3mm jack
Timer On/Off
Power On/Off
FOG
6,3mm jack
Power
indicator
(green)
On/Off Switch
Transmitter
Control Button
Indicator
6,3mm jack
Cover
Receiver
box
Hook
www.audiovias.com
