SGM
GB
Fazer 1000
7
10.
M
AINTENANCE
Do not allow the fog liquid to become contaminated. Always replace the caps on the fog liquid container and
the fog machine liquid tank immediately after filling. After every 40 hours of continuous operation, it is
recommended to run a cleaning solution composed of 80% distilled water and 20% ACETIC ACID through
the system to prevent the accumulation of particulate matter in the heating element.
The recommended cleaning regimen is as follows:
1
Empty all fog liquid from the machine. Add cleaning solution (about 500ml) to the tank. Plug unit in and
begin warming up.
2
Run the unit in a well-ventilated area until the tank is almost empty. Do not allow the pump to run dry.
3
Replace nozzle.
4
Cleaning is now complete. Refill with fog liquid. Run the machine briefly to clear any cleaning solution
from the pump and heater.
5
Do not operate the fog machine without liquid at any time.
Note
: All fog machines are prone to clogging due to the thick consistency of fog liquid and the high
temperature at which it vaporizes. However, a properly maintained fog machine should provide years of
reliable use.
Clean with a dry cloth only. Store dry. Cleaning your fog machine regularly will help reduce costly
replacement and repair charges.
11.
S
TORAGE
1.
When storing run distilled water (not tap water) through the system as described in the cleaning regimen
above. This will help avoid any particles condensing inside the pump or heater.
2.
It is strongly recommended to test-run the machine on a monthly basis in order to achieve its best
fogging condition. A test-run consists of warming up the machine followed by a few minutes of emission.
After that, follow Step 1 under Storage.
Cleaning your fog machine regularly will help reduce costly parts replacement and repair charges.
12.
P
ERFORMANCE
N
OTES
It is recommended that you set the Fan output at 100% and Fog Volume output at 15-20%. With such setting,
you will have continuous output of very fine haze effect
Whenever enormous effect is required, press Manual key to emit faze at 100% output instantly.
For quiet operation, lower down Fan output as desired.
Fazer 1000 has a recycling period after long bursts(About 35- 40seconds) when the machine will shut itself
down for a short period (about 80seconds) in order to heat up again. During this time, no fog can be
produced.
13.
S
PECIFICATIONS
MODELS
FAZER 1000
POWER
AC100V - AC120V - AC230V - AC240V, 50Hz-60Hz
HEATER
1,000W
OUTPUT
105 m3/min
OUTPUT PRESSURE
0.686 pa
HEAT UP TIME
10Min
FLUID CONSUMPTION RATE
45 min / liter (100% Output)
120 min / liter (30% Output)
TANK CAPACITY
2,4Liter
WEIGHT
20,5kg
DIMENSIONS (LxWxH)
653x275x281 mm
www.audiovias.com
