4
4.
Description
Refer to the illustrations on page
2
.
1 Nozzle
2 Mointing
bracket
3
liquid tank with screw cap
4
Controller
4a Wireles remote
5. Installation
Refer to the illustrations on page
2
of this manual.
a) Smoke
liquid
•
Unplug the device
[8]
before filling the tank
[3]
.
• Only use non-inflammable water-based smoke fluid without oil or grease, such as FLN-5 (5 litres) or FLG-5
(5 litres high density smoke liquid)
• Non-recommended smoke liquid may damage the machine and void the warranty.
1. Unplug the device from the mains
[8]
.
2. Unscrew the cap from the tank
[3]
.
3. Carefully pour smoke liquid into the tank (do not overfill it!).
4. Close the screw cap firmly.
5. Gently slide the feeder tube
[9]
into the reservoir until the tip touches the bottom.
Remark: Do not operate the device when the tank [3] is open.
b) Fuse
•
Only fit or replace a fuse when the device is unplugged from the mains.
• Replace a blown fuse with a fuse of the same type and rating (see “
8.Technical Specifications
”):
1. Unplug the device from the mains
[8]
.
2. Unscrew the fuse holder
[6]
at the back with an appropriate screwdriver.
3. Remove the old fuse and install a new one.
4. Replace the fuse holder
[6]
and fasten it with the screwdriver.
c) Mounting
the
device
Note:
when mounting the device under an angle, do not fill the tank
[3]
completely to avoid spilling liquid from
the tank into the machine.
• Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable norms.
• The construction to which the device is attached should be able to support 10 times the weight of the device
for one hour without deformation.
• The installation must always be secured with a secondary attachment e.g. a safety cable
• Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified
technician check the device once a year and once before you bring it into service.
• Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
• Overhead mounting requires extensive experience: calculating workload limits, determining the installation
material to be used… Have the material and the device itself checked regularly. Do not attempt to install the
device yourself if you lack these qualifications as improper installation may result in injuries.
• Make sure there is no flammable material within a 50cm radius of the device.
• Have a qualified electrician carry out the electric connection.
• Connect the device to the mains with the power plug
[6]
. Don´t connect it to a dimming pack.
• The installation has to be approved by an expert before the device is taken into service.
6. Use
Refer to the illustrations on page
2
of this manual.
• Connect the device to the mains
[6]
and flick the power switch
[7]
at the back of the device to ON.
After the warm-up time (approx. 8 minutes) the device is ready for use. The red indicator light
[4/4a]
is now lit.
• Activate/deactivate the smoke output with the push button
[4/4a]
.
• It may happen that the standby lamp on the controller [4/4a] is off and the smoke emission stops, even while
you are holding the button. In this case the device is warming up again and will be ready to resume operation in a few
minutes´ time. This process guarantees an appropriate vaporization temperature and the best smoke emission
possible.
5
controller input
6
fuse holder
7
power ON/OFF switch
8
power cord
9
feeder tube
10
liquid level window
