SEW-Eurodrive MOVIDRIVE MDR60A1320-503-01, Руководство по эксплуатации, Страница: 12 / 32

3
Electrical installation
Electrical connection
Addendum to the Operating Instructions – MOVIDRIVE
®
MDR60A1320-503-01 regenerative power supply
12
4. It is possible to connect one or more drive controllers at this site, even with differ-
ent power ratings. Keep the DC connection cables as short as possible even when
connecting several drive controllers! Route the cables as closely as possible.
5. The option of an external ON or RESET takes place via terminal pairs X2:11 and
X2:12 (chapter "Terminal assignment control terminal strip X2" (→ 2 12)):
• X2:11 and X2:12: Positive impulse (DC 12 to 24 V); can be implemented
through PLC control (terminal 11 +, terminal 12 -).
3.2.2 Control cables
• Connect the control cables to the control terminal strip X2 (→ section "Terminal as-
signment control terminal strip X2").
• Do not route the control cables parallel to motor cables, which emit interference.
• Apply the shielding of the control cables over a wide area of the metal cable
glands on the flange.
3.2.3 Control connections
Use the terminal control strip X2 to connect via relay certain messages such as ready
for operation or a collective fault outside the unit. You can also perform an external
RESET or switching function via the control terminal strip X2 and link it with the fre-
quency inverter.
3.2.4 Terminal assignment control terminal strip X2
12 11 10 9 8 7 6 5 4 3 2 1
+ -
[1] [2]
[3] [4] [5]
37346745739
[1] X2:1 to X2:4 relay collective fault
[2] X2:5, X2:6 Internal assignment for temperature monitoring. Do not connect any
cables!
[3] X2:7, X2:8 External OFF
[4] X2:9, X2:10 not assigned
[5] X2:11, X2:12 = ON / RESET
NOTICE
Do not connect any external voltage to terminals X2:5 and X2:10 because otherwise
the unit may be damaged!
27789314/EN – 07/2022