4
Assembly and installation
Electrical installation
Assembly and Operating Instructions – Parallel Arm Kinematics Kit
27
•
Only use mounting and locking elements that fit into the existing bores, threads
and countersinks.
•
Observe the relevant minimum distances and clearances.
•
Ensure that there is no risk of collision with other components or construction ele-
ments along the travel path after installation.
•
Ensure that all display and diagnostic elements (such as LEDs, displays and dia-
gnostic interfaces) are visible and accessible after installation.
WARNING
Risk of crushing if the load falls.
Severe or fatal injuries.
•
Do not stand under the load.
•
Secure the area where loads can fall down.
CAUTION
Risk of injury due to protruding parts
Risk of cutting or crushing injuries
•
Secure sharp and protruding parts by using cover plates.
•
The installation may only be carried out by trained specialists.
Drive
Observe the following rules:
•
The specifications on the nameplate of the drive must correspond to the supply
system or the output voltage of the frequency inverter.
•
The drive is undamaged (no damage caused by transportation or storage).
•
The following provisions are met:
– Ambient temperature between -20°C and +40°C
– No oils, acids, gases, vapors, radiation, etc. in the environment
– Installation altitude max. 1000 m above sea level
– The limitations for encoders are observed
– Special versions: Drive configured in accordance with the ambient conditions
INFORMATION
The mounting position for installation must correspond to the specifications on the
nameplate.
4.3
Electrical installation
Prefabricated cables are provided to connect the majority of components. You can or-
der these cables from SEW‑EURODRIVE.
If you require additional cables, the team at SEW‑EURODRIVE will be happy to assist
you in selecting them.
25797530/EN – 04/2018
