SEW-Eurodrive F 157 Series, Руководство по сборке и эксплуатации

Страница: 176 / 212

8
Technical data
Lubricants
Assembly and Operating Instructions – Explosion-Proof Gear Units
176
8.2 Lubricants
Unless a special arrangement is made, SEW‑EURODRIVE supplies the drives with a
lubricant fill adapted for the specific gear unit and mounting position. The mounting po-
sition (see chapter
" Mounting positions" (→ 2 136 )) must therefore be specified in the
drive order. You must adapt the lubricant fill in case of any subsequent changes made
to the mounting position (see chapter "Lubricant fill quantities" (→
2 188)).
8.2.1 Bearing greases
The gear unit rolling bearings are given a factory-fill with the greases listed below.
SEW‑EURODRIVE recommends re-greasing the rolling bearings with a grease filling
at the same time as changing the oil.
The table shows the lubricants recommended by SEW‑EURODRIVE:
Area of operation Ambient temperature Manufac-
turer
Type
Standard
-40 °C to +80 °C Fuchs Renolit CX-TOM 15
1)
-40 °C to +80 °C Klüber Petamo GHY 133 N
2)
-40 °C to +40 °C Bremer &
Leguil
Cassida Grease
GTS 2
Oil Oil
3)
-20 °C to +40 °C Fuchs Plantogel 2S
1) Bearing grease based on semi-synthetic base oil
2) Lubricant for the food processing industry
3) Easily biodegradable lubricant for environmentally sensitive areas
INFORMATION
The following grease quantities are required:
• For fast-running bearings (gear unit input side): Fill the cavities between the
rolling elements one-third full with grease.
• For slow-running bearings (gear unit output side): Fill the cavities between the
rolling elements two-thirds full with grease.
8.2.2 Lubricant table
NOTICE
Selecting improper lubricants may damage the gear unit.
Possible damage to property.
• Observe the following information.
24804134/EN – 05/2018