9
8
Functions:
Speed Mode
- Changes wind speed from
Eco to Low to Medium to
High .
Wind Mode
- Changes the wind mode from
Normal Wind to Natural Wind to Sleeping
Wind.
(1) Normal Wind
is indicated by
no
icon
appearing in the upper left hand corner
of the display.
(2) Natural Wind
is indicated by a blinking
triangle icon appearing in the upper left hand
corner of the display.
(3) Sleeping Wind
is indicated by a
solid
triangle icon appearing in the upper left hand
corner of the remote.
Timer
- Changes the time, the fan is on from 0.5 hr up to a max of
7.5 hr, in 0.5 hr increments.
Oscillation
- Turns the fan oscillation
ON
or
OFF
*The remote control operates
on 2 AAA batteries.
*DO NOT MIX OLD AND NEW BATTERIES
*DO NOT MIX ALKALINE, STANDARD
(CARBON-ZINC) OR RECHARGEABLE
(NICKEL-CADMIUM) BATTERIES.
*It is recommended that the batteries
be removed should the remote not
be in use for an extended time.
*
Install the two “AAA” batteries
supplied as shown.
To use your remote, point the top end directly at the front of the
fan aiming at the little window just below the control panel on
the top of the fan.
Power Button
-Turns fan
ON
&
OFF
blinking
solid
1) To clean your fan, first turn it OFF & unplug it.
2) Use a soft cloth to wipe the housing. DO NOT use water, gasoline, polish,
or any chemical solution. Do NOT soak/immerse fan in water/liquid.
3) You can use a vacuum cleaner (narrow tube with the brush attachment)
to clean all intake and exhaust vents. This will remove dirt and lint that
may accumulate over time. DO NOT ATTEMPT TO TAKE APART FAN.
4) For a Super Clean. Suggest you take fan outdoors and use “Compressed Air”
(used to clean computers and electronics) and blow out dust thoroughly.
5) Store in a dry place away from excessive heat and direct sunlight.
This equipment has been tested and found to comply with the limits for Clss B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reason-
able protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may caused harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
.
Reorient or relocate the receiving antenna.
.
Increase the separation between the equipment and the receiver.
.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
.
Consult the dealer or experienced radio/TV technician for help.
WARNING:
Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user authority to operate the equipment.
Storage & Cleaning Instructions
Batteries
Front of Remote
Back of Remote
ECO
LO
HI
MED
ULTRASlimline Remote Control for Tower Fan
Note
