Step 2.
NOTE:
Step 3.
Install Leg Piece (#5-B).
A: Open
box
and put parts aside.
A
ttach the "L" Bracket (#47) to the Leg Piece (#5-B), us
ing
4
pcs Screw I
(#50)
to tighten. Repeat Step A to install "L" Brackets (#47) to another Leg Piece (#5-B) with another
4 pcs
Screw I (#50).
Note: Tighten all the screws after the Brackets (#47) are flush with the Leg Piece (#5-B).
Leave the Solid Hardwood Top (#1) on cardboard to reduce the chance of scratching during assembly.
B: Attach the Leg Pieces (#5-B) to the back of the Solid Hardwood Top (#1), line up the screw holes,
us
ing
16 pcs of
Screw I (#50) and Screwdriver (#21) to tighten.
Install (#48-2) Small Drawer Left Support,
(#48-3) Small Drawer Right Support.
Attach the (#48-2) Small Drawer Left Support
to the bottom of (#1) Solid Hardwood Board,
line up the screw holes, use (#50) Screw I
and (#21) Screwdriver to tighten.
Repeat this step to install (#48-3) Small
Drawer Right Support.
TIP: A magnetic screwdriver is included for your convenience.
If
using a
power screwdriver
, keep torque setting on LOW.
Do not fully tighten the screws. This will help
you make any adjustments for alignment.
Install Bottom Cross Bar (#3-B) and Leveling
Feet (#6).
Attach the Bottom Cross Bar (#3-B) to the back
of Leg Piece (#5-B), line up the screw holes,
use 4 pcs of Screw E (#40) with Washer (#27-B)
and Wrench (#25) to tighten.
After installing the Bottom Cross Bar (#3-B),
attach Leveling Feet (#6) to the Leg Pieces
(#5-B)
, use Wrench (#25) to tighten.
UltraHD® Pegboard Workcenter (Model No. 20168)
*NOTE: We recommend using TWO people to assemble the workbench.
2
NOTE:
Front
Back
