UltraHD® Dual Motor Electric Height Adjustable Workbench (Model No. 20200)
Quick Reference Guide
Power ON the workbench
:
When the workbench is plugged
in, you will hear a "Beep" sound.
The Controller will then show the
current height of the workbench.
The number indicated on the
display may be different to the
actual height, it will need to be
reset.
DISPLAY
UP/DOWN
MEMORY 1/2/3
SAVE MEMORY
How to Reset
Press and HOLD the
button until the workbench reaches it reaches the lowest height. Continue
to press
and HOLD for about 5 seconds until you see a number (ie. 29.6) on the display AFTER it
shows “rst” and makes the “beep-beep” sound.
How to Adjust the Height
Press and HOLD either the or to adjust to your desired height of the workbench.
How to Lock/Unlock the Controller
First adjust the workbench height to your desired lock height. Then press and HOLD the
and
buttons
together
for about 5 seconds until “Loc” is displayed.
At this moment, the Controller is locked and the
workbench height can’t be adjusted.
In order to unlock, press and HOLD the
and
buttons
together for about 5 seconds until a
number (previously locked height) is displayed.
Power Save Mode
If there is no
action for
1 minute,
the workbench
will enter the power-saving mode. The display
on the
C
ontroller will be turned off. Press any button
on the Controller t
o
wake the workbench
from “Power Save Mode”.
How to Save the Height in Memory
There are 3 available memory heights you can save - 1, 2 & 3. Adjust the workbench to your
desired height and press the “S” button to display “S-“. Then press any of one the 1, 2 or 3 number
button. When a memory is saved, you will hear “beep-beep” sound.
By repeating the same steps, you can save or override an old saved memory with a new height.
Please
see reversed side
for the
c
omplete list of
e
rror codes and troubleshooting steps for
this
w
orkbench.
