12
ENGLISH
Initial operation
The luminaire is only to be connected to an alternating current – with the voltage according to the rating plate – to a properly
installed safety socket. Please note that your system corresponds to the relevant VDE guidelines.
If you have any questions about this, please contact your energy supplier or your electrician. Of course we are at your disposal
if you have any questions.
ATTENTION!
In the case of versions of the luminaire with other plug-in systems (not Schuko®), the voltage according to the rating
plate must be observed.
Operation
1. Installation for operation with tripod / mast systems
INFORMATION!
• The luminaire can be operated on various tripod / mast systems.
A mast mount is available on the luminaire for this purpose. The
mount is suitable for a DIN bolt (d = 30 mm).
• The luminaire may only be operated in connection with a tripod /
mast system which is equipped with a standard pin according to
DIN 14640.
• Operation of the luminaire is only permitted up to a maximum
wind speed of 100 km/h.
Safe operation cannot be guaranteed in stronger winds.
Connect the luminaire to the bolt receiver (C) and the tripod / mast system. Lock the
ALDEBARAN® 360 GRAD FLEX LED
600 COMPACT BASIC / ALDEBARAN® 360 GRAD FLEX LED 240 COMPACT 24 V DC IP65
using the star grip (B).
ATTENTION!
• Make sure the tripod / mast system can support the weight of the luminaire. For safe operation, the instructions
for the tripod / mast system must be observed.
• The
ALDEBARAN® 360 GRAD FLEX LED 600 COMPACT BASIC / ALDEBARAN® 360 GRAD FLEX LED 240
COMPACT 24 V DC IP65
requires room / ambient air for proper operation. The luminaire must be installed free-
standing with at least 0.5 m clearance on all sides.
• Make sure that the active cooling (fan) is not affected by dirt
(ALDEBARAN® 360 GRAD FLEX LED 600 COMPACT
BASIC)
.
WARNING!
• When operating with a tripod or mast, it must also be ensured that this is sufficiently stable. It is important to ensure
that it is on a level surface. Inclinations are to be avoided.
• Be sure to fix the luminaire with the star grip after it has been placed on your tripod / mast system. This is how you
avoid accidents.
• Lay the cables in such a way that there are no tripping hazards and they are protected from mechanical damage
such as tearing off or being run over.
• If necessary, secure the cables with tape or cable ties.
• Make sure the luminaire is securely set up and fastened before use.
• Also observe the applicable regulations on occupational safety!
• The protective film on the front pane may need to be removed before using the luminaire.
