MS-900SPW4 Pairing with Wireless Headset – Headset Information
3019 Alvin DeVane Blvd.
Ste. 560
Austin, TX 78741
Phone: (650) 965-8020
CORPORATION
®
TECH SUPPORT: 650-965-8020 ext. 703
Questions or technical issues? Please call:
Page 3 of 5
CSB-900W4
Wireless
Headset
The CSB-900W4 Wireless Headset is shipped already paired to the MS-900SPW4.
See below for pairing information if needed.
The MS-900SPW4 and a wireless headset will retain pairing identity whenever
powered off and power on again.
Turn on the headset by turning the Volume Control knob Clockwise. The headset will
beep 1 to 3 times indicating battery charge level:
0 Beeps = fully discharged battery / charging required
1 beep = low battery / charging required
2 beeps = moderate charge remaining
3 beeps = full charge
When powered on, the headset will link to the MS-900SPW4 within about 5 seconds,
then will beep 3 more times, from a low tone to a high tone, indicating the link was
successful. The LED’s on the headset and the MS-900SPW4 will both slowly flash
Green indicating linked status.
If the headset needs to be re-paired with the MS-900SPW4, or paired with another MS-900SPW4:
1) Disconnect the Portable Radio Adaptor Cable (PRAC) from the headset, if one is installed (re-connect after pairing).
2) Set the MS-900SPW4 for Pairing Mode (press and hold Pairing Button about 3 seconds, until Status LED slowly flashes Amber).
3) Turn on the wireless headset, and after the charge indicator beeps press and hold the 2 PTT buttons on the bottom of the
cups at the same time, after a few seconds there will be a low beep, then release the buttons.
4) After a few seconds the headset will beep again 3 times, from low to high pitch, indicating that the pairing was successful. The
LED’s on the headset and the MS-900SPW4 should now be slowly flashing Green.
For further details and instructions, refer to the CSB-900W4 Wireless Headset User Guide, found on the Setcom website:
www.setcomcorp.com
. A video of the pairing process can be found at: www.setcomcorp.com/cr/900wireless.php.
