- 3 -
English
- GB.3-V1 -
PREPARING TO TEST
Κ
1.
Be sure area around battery is well ventilated while
battery is being tested.
2.
Clean battery terminals. Be careful to keep corrosion
from coming in contact with eyes.
3.
Inspect the battery for cracked or broken case or cover. If
battery is damaged, do not use tester.
4.
If the battery is not sealed maintenance free, add distilled
water in each cell until battery acid reaches level
specified by the manufacturer. This helps purge
excessive gas from cells. Do not overfill.
5.
If necessary to remove battery from vehicle to test,
always remove ground terminal from battery first. Make
sure all accessories in the vehicle are off to ensure you
do not cause any arcing.
INSERTION OR REPLACEMRNT OF LEAD WIRE
Κ
1.
Remove the cover in the backside bottom of the battery
tester.
2.
Insert the connectors which contain black-yellow pair
and yellow-red pair in one end of the lead wire into the
sockets which can be found when you remove the
cover as above. Be sure to make colors matched
between the connectors and sockets as shown below.
Black
White
(RT777 Backside)
Yellow
Black white
Red (Connector)
Yellow (Socket)
Red
Connect