Sesamo DUALCORE LH100, Руководство по установке

Страница: 22 / 73

22
SESAMO DUALCORE
AUTOMATED SYSTEM COMMISSIONING
The commissioning of the Dualcore automated system with P56001 version board and
sensors compliant with EN16005 standard requires the following sequence:
1- mains power connection (230Vac) and batteries (optional);
2- Learn Parameters (LP) procedure;
3- Learn Sensors (LP) procedure;
4- possible adjustment of parameters;
5- check of the correct tightening of all screws, of the carriages anti-derailment, of
the box and of all the parts subject to stress and vibrations during operation;
6- final check of the correct operation of all the safety devices installed with the use
of the specific equipment required by EN16005;
DANGER: each of the activities 1 to 6 listed above is fundamental to the safety of the
system; ensure the person responsible is suitably qualified and do not skip any steps or
checks. Otherwise an important safety function may be disabled and the automatic
movement of the doors may cause serious injury or damage to persons or objects, risking
potentially fatal lesions.
Connect the batteries (if present) and the mains cable (230VAC) to the control unit then
proceed with the self-learning Lp. Refer to fig. 34 of the manual for the passage of the mains
cable from inside to outside of the automated system.
WARNING: if no optional device for night closing control is installed, make sure that
the KEY input is shorted out with the appropriate COM input (terminals 22 and 23);
conversely, it is not possible to start the automated system. For RD100 model, the
connection to the KEY input is in series with the selector switch. Make sure that the key is
set to ON position (led key access).
WARNING: for model RD100, make sure that the emergency button is ON = contact
closed and AUX IN2 led on
PARAMETER ACQUISITION PROCEDURE
(LP)
The parameter acquisition procedure (LP = learn parameters) allows the control unit to
acquire essential data for operation such as the size of the sliding compartment, the weight
of the leaves and the opening direction.
IMPORTANT: before carrying out the LP, make sure that there are no obstacles or excessive
frictions that hinder the sliding of the leaves. Carefully check all the mechanical parts inside
the automated system that interact with the sliding (wheels, carriages, anti-derailment
devices, belt, etc.) and all fixtures in the mobile and fixed parts with particular reference to
the floor guides and the air tightness gaskets or brushes which can be a brake on the sliding
of the leaves. Otherwise, the procedure may not end and could lead to product malfunctions
or excessive wear of some parts.