4. MOTOR CONNECTIVETY WITH GEARBOX
SESAME MOTOR CORP.
：
http://www.sesamemotor.com.tw/
E-mail: [email protected]
TEL: +886-4-2561-0011
FAX: +886-4-2562-7766
Check the motor and gearbox size.
Clean the mounting surface.
4.1
Take off the plug from the adapter plate.
Revolve the set collar until the bolt is aligned
with the hole.
4.2
Make sure the motor
shaft size. Choose
the right bushing if
necessary.
4.4
As installing on flatted
shaft, be sure to align the
collet gap over the flat and
the set collar bolt perpen-
dicular to the flat.
Tighten the mounting screws in
1~4 order with torque wrench to
5% specified torque.
4.5
Tighten the mounting screws in 1~4
order with torque wrench to speci-
fied torque.
4.7
Tighten the set collar bolt with
torque wrench to specified torque.
4.6
Power on the motor. Slowly drive the
motor and adjust its mounting status
until the gearbox is driven smoothly.
5.1
If the problem could not be solved
via the procedures above, please
DO NOT take apart of the motor,
contact SESAME for technical sup-
port right away.
5.2
Attention
Apply our product with other, please ensure it matchother’s
requirement, specification, or limitation.
Customer need to recheck our product is
suitable for their
current system or machinery usage.
If customer is neglecting for rechecking, then
Sesame is
not responsible for any cause
there might occur.
Put the plug back on the adapter plate.
4.8
Remove the key from the motor
shaft. Mounting the balance key if
necessary.
4.3
Ensure the plug was
installed before start
the motor.
。
Do not touch any
rotating component
when the gearbox
is running.
Page 3 / 4
Page 4 / 4
SESAME MOTOR CORP. / Planetary Gearbox Operation Manual V1.3
SESAME MOTOR CORP. / Planetary Gearbox Operation Manual V1.3
5.
TEST RUN & TROUBLE SHOOTING GUIDES
Bolt Size
Width Across Flats
Strength 8.8
Tightening Torque
Strength 10.9
Tightening Torque
Strength 12.9
Tightening Torque
Tightening Torque
In-lb
19
44
87
151
364
709
1232
1976
3038
N-m
2.1
4.9
9.8
17
41
80
139
223
343
In-lb
16
37
73
124
302
594
1028
1648
2534
N-m
1.8
4.1
8.2
14
34
67
116
186
286
In-lb
12
27
55
98
222
434
753
1214
1860
N-m
1.3
3
6.1
11
25
49
85
137
210
mm
2.5
3
4
5
6
8
10
12
14
M3*0.5P
M4*0.7P
M5*0.8P
M6*1P
M8*1.25P
M10*1.5P
M12*1.75P
M14*2P
M16*2P
