Servomex 07931001B, Руководство оператора

Страница: 42 / 221

28
© Servomex Group Limited. 2020 07931001B revision 6
3.10 Password protection
Passwords must be set when the unit is first powered up to ensure
proper operation.
Passwords should be kept in a secure place.
Note: Passwords are displayed as asterisks (*) when entered, for security purposes.
Note: The password remains active until 10 minutes after the last time you press a
soft-key. If you do not press any soft-key within that time, you must re-enter the
password.
Note: Holding down the soft-key will clear the current security level and return the
display to the measurement screen.
The Laser 3 Plus does not contain factory set operator or supervisor passwords.
This means that when the Laser 3 Plus is first powered up after installation it does
not have operator or supervisor passwords set. This is indicated by a maintenance
fault being raised. This can be seen in the status log as shown below.
To clear the fault new passwords must be set
To do this, navigate to Settings, User Settings, Password, Set Passwords as shown
below
Set both the operator and supervisor passwords