Servomech ATL 50, Инструкция по установке, эксплуатации и обслуживанию, Страница: 21 / 21

Servomech S.p.A. 02.50-63-80.E - Rev. 03 Date (M/Y) 12/19 21
9.2 Push rod guide lubrication
WARNING! THE PLANT MUST BE STOPPED BEFORE BEGINNING ANY MAINTENANCE OPERATION.

Relube the push rod guide using proper grease nipple, as shown on Fig. 9.3.

Grease nipple type: DIN71412 M6.
Figure 9.3 – Push rod guide grease nipple

Apply the grease quantity indicated in Tab 9.1.

In case of extra guide option, 2 grease nipples are placed on the actuator. Lubricated both grease
nipples with quantity indicated in Tab. 9.1.

Extend and retract the push rod over its entire stroke for 3 full cycles.

If necessary, remove excess of lubricant from push rod.
9.3 Rear hinge lubrication
WARNING! THE PLANT MUST BE STOPPED BEFORE BEGINNING ANY MAINTENANCE OPERATION.
REAR HINGE RELUBRICATION IS ONLY REQUIRED FOR ACTUATOR ATL/BSA 63-80.

Relube the rear hinge using proper grease nipples (n°2 grease nipples, as shown on Fig. 9.4).

Grease nipple type: DIN71412 M6
Figure 9.4 – Rear hinge grease nipples

Apply the grease until the steel bush is filled.

If necessary, remove excess of lubricant from the hinge pin.
Ingrassatori della guida stelo (2×)
Push rod guide grease nipple
Ingrassatori della guida stelo (2×)
Rear hinge grease nipples (2×)