Quick
Installation
Guide
SL
‐
DKAU
‐
100
DVI
KVM
Extender
over
IP
or
CAT
5
up
to
100m
3
Rev.
1.1
Copyright
@
All
Rights
Reserved
Installation
Please Note:
Before installation, ensure that the 4 Position
Dip Switch of the Transmitter and Receiver Units are set to
the same positions (The default setting for all switches is
ON)
Configure the Transmitter Unit
Step 1.
Connect one end of the CATx UTP cable to the
CAT5 Extension port of the Transmitter.
(connector f)
Step 2.
Connect the power adapter to the Transmitter to
power it up before connecting any computer or
cables to it. (connector
g
)
Step 3.
Connect the Transmitter’s DVI port (connector
i
)
to the computer’s DVI output port using the
included DVI cable.
Step 4.
Connect the Transmitter’s USB port (connector
h
)
to the computer’s USB port using the included
USB cable.
Step 5.
Connect the speaker port (connector
k
) to the
audio out port of the computer
Step 6.
Connect the microphone port (connector
j
) to the
microphone input port of the computer
Step 7.
Power on the computer and make sure your local
DVI monitor is working before proceeding to the
next steps.
Configure the Receiver Unit
Step 8.
Connect the other end of the CATx UTP cable to
the CAT5 Extension port of the Receiver.
(connector
10
)
Step 9.
Connect the power adapter to the Receiver
(connector
11
) to power it up before connecting
any devices to it.
Step 10.
Connect a DVI monitor to the DVI Output port.
(connector
15
)
Step 11.
Connect a USB keyboard and USB mouse to the
USB keyboard and mouse ports on the receiver.
You can connect to either port. (connectors
6 & 7
)
Step 12.
Connect a set of speakers (connector
14
)
Step 13.
Connect a microphone (connector
13
)
Step 14.
Connect two optional USB 2.0 devices such as an
external HDD, flash drive, printer, webcam etc.
(connectors
8 & 9
)
Operation
To turn the Remote Console ON/OFF, Short press the Sw 1
button on either TX or RX.
According to your display contents, you can choose
either Graphic Mode or Video Mode to optimize the
video image on the Receiver unit.
Graphic Mode
is
best for still graphic images such as high definition
photos.
Video Mode
is best for dynamic display
contents such as movies and video clips that have fast
moving content.
To switch between Graphic Mode/Video Mode, Short press
the Sw 2 button on either TX or RX.
To switch between Anti-Dither 1/2/OFF, Long press the Sw
2 button on either TX or RX.
Trouble Shooting
Q: The resolution of display is reducing to 640 x 480 or
other settings other than 1920 x 1080
A: The monitor EDID should be automatically detected.
However if the connected monitor’s resolution is being
reduced, you may need to manually set the EDID. Please
follow the steps below to detect the EDID of connected
monitor. Note that this procedure is only available on
Receiver (RX) unit.
Step 1. Remove the power adapter from RX unit.
Step 2. Press and hold Sw2 and re-connect power adapter.
Step 3. Release the SW2 when the LED flashes red.
The monitor EDID should now be detected.
