Quick
Installation
Guide
SL
‐
DKAU
‐
100
DVI
KVM
Extender
over
IP
or
CAT
5
up
to
100m
1
Rev.
1.1
Copyright
@
All
Rights
Reserved
Quick Installation Guide
SL-DKAU-100
ServerLink DVI KVM Extender over IP or Cat 5
DVI, USB KB & Mouse, Audio & 2 x USB 2.0
Devices up to 100m
Transmitter (TX) Front View
Receiver (RX) Front View
Introduction
The SL-DKAU-100 DVI Extender over IP or Cat 5 can
extend your DVI monitor, USB keyboard, USB mouse,
audio and two other USB 2.0 devices such as an external
HDD, flash drive or printer up to 100m away from your
computer over a single CAT 5 or CAT 6 UTP cable.
You can connect the Transmitter unit directly to the
Receiver unit using a single inexpensive CATx UTP cable.
You can also use your existing cabling infrastructure and
connect via a standard Gigabit Ethernet Switch.
Since the DVI signal is interoperable with the HDMI
signal, you can use this DVI KVM Extender to extend
your HDMI display using optional DVI to HDMI
adapters.
Package Contents
Please check wand make sure you have all the following
items from the packaging box.
1 x Transmitter Unit (TX)
1 x Receiver Unit (RX)
1 x DVI-D Male to Male Cable
1 x USB Type A to Type B Cable
2 x Power Adapters (DC9V)
Front Panel & Back Panel
Transmitter (TX) Unit
Transmitter (TX) Unit Front View
Transmitter (TX) Unit Back View
Transmitter (TX) Unit Right Side View
[TX Front Panel]
a. Reset
Button
b.
Power LED (Lit when power is on)
c.
Link LED (Lit when link is active)
d.
Switch Button (Yellow – Sw1)
Short press to switch Remote Console ON/OFF
e.
Switch Button (Yellow - Sw2)
Short press to select Graphic Mode/Video Mode
Long press to select Anti-Dither 1/2/OFF
f.
RJ45 Port connect to the RX unit - 100m Maximum
