SPLICE™ MKII MANUAL V.1.1
6
www.serpentaudio.com
Mode Switching:
The Audio path of the SPLICE-500™ MKII consists of two sections; the Input
amplifier circuitry and the Output amplifier circuitry. The SPLICE™ MKII’s unique
circuitry mode switching allows the user to switch the audio path circuitry between
classic Blackface and Blue Stripe modes, or mix and match between the two.
When both Input & Output Mode LED’s are off (Black), the unit is configured for
Blackface mode.
When both Input & Output Mode LED’s are illuminated (Blue), the unit is configured
for Blue Stripe Mode.
Alternatively, the unit can be configured to mix and match the Input & Output circuits,
creating entirely new sounds unique to the SPLICE™ MKII (i.e. Blue Stripe Input
c Blackface Output circuit, or Blackface Input c Blue Stripe Output
circuit)
Note: The default mode when unit is powered on is Blackface.
Note: The switching recovery time for Input mode switching is
approximately 2 seconds when the release knob time is set to its fastest
setting (fully clockwise). Long release time settings will increase the Input
switching mode cycle time.
Slam (AKA All Buttons In):
Slam Mode is a high distortion mode, also known as “All Buttons In”. Slam mode is
engaged when the toggle switch is in the up position. While in Slam mode, the Red
“S” LED will illuminate when no gain reduction is present.
Note: To achieve a classic Slam mode sound, the Ratio must be set to the
“4” or “20” positions with Slam mode enabled. Setting the ratio to 2, 8, or
12 with slam mode enabled will result in different distortion effects.
