For more information and all configuration codes, visit
serialio.com/products/barcode-scanners/bluetooth-wireless/kdc200-series
2
Setting up KDC200/200i in HID mode (like a Bluetooth Keyboard)
Use these instructions to set up your scanner to work as a Bluetooth keyboard – Use these instructions to set up
your KDC200 for use with iOS. To set up your KDC200 with SerialMagic, use the
other side
of this sheet.
1.
Charge
– Connect the KDC200/200i to a powered USB port for about 4 hours.
2.
Set scanner to HID mode
– Scan the following barcode to put your scanner in HID mode (the scanner may
take a moment to change modes):
ÉÁ6A001jËÍ
HID Mode
Make discoverable and connectable
– Scan the following barcode to make the scanner discoverable and
connectable (The KDC200/200i should display “Pairing Started…” when the code is scanned):
ÉÁ6Ä*!gËÍ
Start pairing
3.
Connect from your mobile device or PC
– On your mobile device or PC, start Bluetooth discovery, and
click on or tap the KDC200 device name when it appears. If a confirmation to pair with the KDC200
appears, confirm that you want to connect. The KDC200/200i should display “HID Connected.”
Congratulations!
You are now connected to the KDC200/200i in HID mode.
On-Screen Keyboard:
To toggle the iOS on-screen keyboard on and off, use the “down” arrow on the side
of the scanner.
Disconnecting/Reconnecting:
Use the following barcodes to disconnect & reconnect the KDC200/200i:
ÉÁ6ÄÌ*lËÍ
Bluetooth OFF
ÉÁ6Ä,!oËÍ
Reconnect Last
Setting up KDC200i in MFi mode
To use this mode, you must have software with MFi (made for iOS) scanner support, such as Grid-in-Hand™
Mobile Grid
1.
Charge
– Connect the KDC200i to a powered USB port for about 4 hours.
2.
Set scanner to MFi mode
– Scan the following barcode to put your scanner in MFi mode:
ÉÁ6A002pËÍ
MFi Mode
3.
Make discoverable and connectable
– Scan the following barcode to make the scanner discoverable and
connectable (The KDC200i should display “Pairing started…” when the code is scanned):
ÉÁ6Ä*!gËÍ
Start pairing
4.
Connect from your iOS device
– On your iOS device, start Bluetooth discovery, and tap the KDC200 device
name when it appears. If a confirmation to pair with the KDC200 appears, confirm that you want to
connect. The KDC200/200i should display “iPhone/iPad Connected.”
5.
Connect to the KDC200i from inside your MFi app
– Refer to you application’s documentation for
instructions on connecting an MFi scanner.
In Grid-in-Hand™ Mobile Grid, you can connect to the KDC200i by clicking on the “
” icon in the lower
left-hand corner of the app, and selecting the KDC200i from the list of MFi devices.
Congratulations!
You are now ready to scan data into your MFi app.
