For more information and all configuration codes, visit
serialio.com/products/barcode-scanners/bluetooth-wireless/kdc200-series
1
Your serial solution provider on
over 500 mobile device models
KDC200/KDC200i
Bluetooth Laser Barcode Scanner
Quick Start Guide
715 Discovery Blvd. Ste. 510
Cedar Park, TX 78613
Tel: (512) 994-3630
Fax: (866) 546-4523
For sales inquiries:
For technical support:
Setting up KDC200/200i in SPP Mode (SerialMagic mode)
Use these instructions to set up your scanner for use with SerialMagic or SerialMagic Gears. To use the
KDC200 as a Bluetooth Keyboard (all iOS devices), refer to the instructions on the other side of this sheet.
1.
Charge
– Connect the KDC200i to a powered USB port for about 4 hours.
2.
Set scanner to SPP mode
– Scan the following barcode to put your scanner in SPP mode:
ÉÁ6A000dËÍ
Bluetooth SPP
3.
Set up SerialMagic
serialio.com/products/SerialMagic/SmSuppPlat.php
Download & install SerialMagic for your platform. Then, launch SerialMagic, and scan for devices.
4.
Make discoverable and connectable
– Scan the following barcode to make the scanner discoverable
and connectable (The KDC200/200i should display “Pairing started…” when the code is scanned):
ÉÁ6Ä*!gËÍ
Start pairing
5.
Connect
– Use SerialMagic to pair the KDC200/200i with your mobile device or PC. You should not be
required to enter a PIN. If a confirmation to pair with the KDC200 appears, confirm that you want to
connect. The KDC200 display should read “Bluetooth Connected.”
Congratulations!
You are now ready to start scanning data into your mobile device or PC.
Disconnecting:
When done using the KDC200, click “Stop” or quit SerialMagic to disconnect the
scanner. After disconnection, the KDC200/200i Bluetooth radio will remain on for 5 minutes (by
default) allowing you to quickly reconnect. The scanner will emit a long beep when the radio turns
off after this time.
Reconnecting:
Turn on the KDC200/200i Bluetooth before reconnecting through SerialMagic by
scanning the “Bluetooth ON” barcode below. Alternatively, scan the “Enable BT Auto-On” barcode
below to enable Bluetooth Auto-On, and then press the scan button to enable Bluetooth.
ÉÁ6ÄÌ!?ËÍ
Bluetooth ON
ÉÁ6ÄÌ*lËÍ
Bluetooth OFF
ÉÁ6Ä\!aËÍ
Enable BT Auto-On
