Two-part Valve
Top screws into bottom
half that is inside tube
Needle Spring
Valve Adapter
You can also use the valve adapter to
help secure the inflator to the opening
www.SereneLifeHome.com
5
• Start the watercraft and move slowly to remove slack until the tow rope is tight.
• When the rider signals READY and there is no traffic ahead, take off in a straight line.
Adjust the speed according to the signals given by the rider.
RIDING:
The watercraft and rider should always maintain a sufficient distance from obstacles so a rider
falling or coasting and/or watercraft will not encounter any obstacle.
•
Do not use in shallow water or near shore, docks, pilings, swimmers, other watercraft, or any other obstacles.
• Use only on water.
• Never attempt land or dock starts. This will increase your risk of injury or death.
• Always wear a properly fitted life jacket (PFD) approved by your country’s agency, USCG Type III, ISO, etc.
• The faster you ride, the greater your risk of injury.
• Never make sharp turns that may cause a slingshot effect on the tube’s speed.
• Rider should be towed at an appropriate speed for their ability level.
FALLEN RIDER:
Falling and injuries are common in riding.
• Circle a fallen rider slowly to pick up the fallen rider.
• Put the watercraft in neutral when near a fallen rider.
• Always keep the fallen rider in view and on the driver’s side of the watercraft.
• Display a red or orange-down flag to alert other vessels that a rider is down.
The Warnings and practices in the Watersports Safety Code represent common risks encountered by users.
The code does not cover all instances of risk or danger. Please use common sense and good judgment.
BANANA BOAT INFLATION
Inflating your banana boat
To open the valve, simply push down the yellow-topped needle spring and turn to the right while in the
down position. The needle spring will
stay down
and the valve will be open. You can then simply put any
inflator to this opening and fill the banana until firm. Once it is firm, quickly remove the inflator and push
down the needle spring and turn to the left - it will pop back up to the closed position.
