Switch Type
Status
Notification Type
Reed Switch
0x06
Tamper Switch
0x07
Event
Reed Switch
Close:0x17, Open:0x16
Tamper Switch
Close:0x00, Open:0x03
BASIC Report
Reed Switch
Close:0x00, Open:0xFF
Alarm Type
Reed Switch
0x06
Tamper Switch
0x07
Alarm Level
Close:0x00, Open:0xFF
1.
The Green Pairing LED will stay off during the normal operation.
2.
The sensor is equipped with a tamper switch. If the cover of sensor is removed, the sensor will send an alarm
to the home controller.
3.
Tamper switch event will be ignored when in auto inclusion procedure.
FCC Statement:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
The FCC ID for this device is P27SWDWS02N
You are cautioned that changes or modifications not expressly approved by the party responsible for compliance
could void your authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
FCC RF Radiation Exposure Statement:
•
This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
•
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with a minimum distance of 20 centimeters between the radiator and
your body.
Certification
Operation
Notification Type
