Page 5/6
M
T
/B
6
-C
6
I
E
SIN
CE
1
96
5
Fig. 14
Fig. 16
1
2
COVER
"C"
3
FINAL INSTALLATION
13- Remove the motor from the brackets. Weld the front
bracket in its final position.
Fix the rear bracket in its
final position. - Fig. 14 -
14- Refit the motor. Any differences in values B and C can
be compensated for using the 5 holes on the rear brac-
ket. - Fig. 9 -
15- If needed adjust the mechanical stops as per instruc-
tions in following page
17- Fix the covering part
“C”
: incline of few degrees, cou-
ple the pegs properly and close backside, locking it
with the “security key” FIG 16
16- Fix the covering part "B" in the front side with the
screw and washer and in the back side with the flat
screw FIG. 15
ADJUSTMENT OF INTERNAL MECHANICAL STOPS
- Open the covering part
“C”
with the “security key”
supplied with the motor. Picture 17
- Raise the covering part
“C”
backside of few degrees
and remove it without revolving it Picture 18
- Using a 13 mm wrench, set the two front (closing) me-
chanical stops and rear (opening) stops in the required
position. - Fig. 21 -
- Unscrew the back side and the front side screws fi-
xing the covering part "B" - FIG 19 -
- Raise the covering part "B" - FIG 20 -
Fig. 17
Fig. 18
2
1
!
COVER
"C"
COVER
"C"
ATTENTION: the coupling
pegs could brake if the
covering part is inclined
more than 10-15°
Fig. 21
FRONT MECHANICAL STOPS
REAR MECHANICAL STOPS
COVER
"B"
Fig. 20
Fig. 19
Fig. 15
COVER
"B"
