SEON Trooper TR4, Инструкция по установке и эксплуатации

Страница: 23 / 90

Installation
700-0035 R004 2–3
2.2. Step 1: Installing the Lock Box
The lock box has a door and lid which need to be removed in order to secure the
base in its location. The lock box can be mounted either on the floor or underneath
a seat.
The lock box can be installed horizontally (see “Horizontal Installation”). Four
mounting points are located on the base of the lock box for securing the unit and
raising the unit off the mounting surface by 3/16".
The lock box can be installed vertically (see “Vertical Installation” on page 2–4).
Three mounting points are located on the back of the unit for securing the unit and
raising the unit off the mounting surface by 3/16".
2.2.1. Horizontal Installation
To install the lock box horizontally:
1. Unlock the door with the lock box key and remove it from the lock box.
2. Slide the DVR out of the lock box by pulling on the two bracket tabs at the
front of the DVR.
3. Detach the lid from the lock box by removing the two retaining screws on
either side of the lid near the front of the lock box.
4. Determine whether the power and camera cables will enter the lock box on
the left or the right side. If necessary, swap the cable grommet and the hole
plug. See Figure 2-1.
5. Use the four #10 × ¾" sheet metal screws or #10 × 1" self-drilling screws to
secure the base of the lock box to the floor.
6. Slide the lid on to the lock box and secure it with the two retaining screws.
Important:
If you are mounting the lock box under a seat, contact your Seon Design
sales representative or dealer for information on the Underseat Mounting Bracket Kit.
Important:
It is not recommended that the lock box be installed on its left or right side
where the cables enter the unit.
Figure 2-1 Lock box horizontal installation
Hole plug
Cable grommet