Installation and Configuration Guide
700-0116 R003
3
Installation Diagram: DX12 Plus System
Figure 1 shows the connections for the typical DX12 Plus system.
Figure 1
Typical DX12 Plus System
POWER
OUTPUT
ALARM
INPUT
1
2
3
4
5
6
7
8
12
11
10
9
LAN2
LAN3
VIDEO
OUTPUT
CONTROL
SMARTLINK
EXTERNAL
DRIVE
POWER
Explorer® DX12
Typical Plus System Setup
Remote Microphone
*1
Smart-Link™
Supports 12 Cameras
GPS Receiver
*
4
8 wires
3 wires
Seon internal
use only
Diagnostic Indicator/
Alarm Button
5 wires
Smart-Reach
®
Mobile (Wi-Fi) *
2
Laptop *
2
LCD Monitor*
3
DX12 DVR Rear Panel
2 wires
IGNITION
Vehicle Sw 12V
(yellow)
Battery Negative
(black)
1A
Seon System
Vehicle Electrical Interface
Peripherals
POWER IN
SIGNALS
POWER ON
LOW VOLTAGE
ALARMS
AUX.
POWER
INDICATOR
PANEL
POWER OUT
TO DVR
GPS
CAN
SPEED
GPS
DB-9
2 wires
SIGNALS
Signal 1 Left Turn
(black)
Signal 2 Stop
(green)
Signal 3 Brake Signal
(red)
Signal 4 Warning
(brown)
Signal 5 Right Turn
(white)
4 wires
ALARMS
Alarm 1
(orange)
Alarm 2
(blue)
Alarm 3
(violet)
Alarm 4
(gray)
Alarm 1-4 Ground
(black)
SPEED
Red – Call Seon if using hall sensor
Green – Speed sensor high
Black – Speed sensor low
10A
POWER
Backup Battery Negative (black)
Backup Battery Positive (red)
Alarm 0 Wake On Function
External Power for IR options
Power On/Off for Wifi bridge
Battery Negative (black)
V 12V (red)
2 wires
10A
Legend:
Connection to optional equipment
*1
The remote microphone requires an optional camera harness if the camera connected to Camera 1 (or Camera 2) does not have a microphone.
*2
An optional Smart-reach Wi-Fi or Laptop can be used from the Ethernet output located on the front or back panel.
*3
An optional LCD Monitor can be used from the video output located on the front or back panel.
*4
For speed tracking, use a GPS receiver or an optional speed harness. For ease of installation and better speed tracking, Seon recommends using a GPS receiver.
