Sentry DCC02, Инструкция по установке и эксплуатации

Страница: 25 / 50

Wall Console Installation Wall Console Installation
25
L
IS
H
E
N
G
The wall console is designed to be affixed to any surface using a variety of screws.
Four keyhole style mounting holes are provided in the base of the wall console for
easy mounting on a variety of surfaces. In most cases the unit will be affixed to a wall,
and the four supplied masonry wall anchors provided, should be used.
Mounting Distance From Motor Head Unit
In most cases, the length of the supplied interconnect cable is the general rule of
thumb. However in some instances it may not be possible to mount the wall console
this close to the motor. The interconnect cable may be lengthened, but by an
additional
2 metres only. This is achieved using three core cabtyre (1,25mm² or
greater).
Mounting Template
To assist with marking off hole locations on the surface where the wall console is to be
mounted, a template is provided, which is located in the centre of this manual and may
be pulled out.
Mounting Considerations
The wall console should be mounted in a location that is dry and not subject to
moisture. It should also preferably be mounted at a convenient height, but not too low
as this would affect remote control reception. Mounting on or near very large metal
structures should be avoided.
4
5
15
Wall console base with
arrows showing keyhole style
mounting holes