Sentiotec 92773, Инструкция по установке и эксплуатации

Страница: 112 / 214

WORLD OF WELLNESS
EN
Instructions for installation and use p. 13/22
4.4. Installing the bench sensor
Refer to Fig. 5 (page 13 ).
1. Lay the two 2-pin bench sensor wires
3
in the wall of the sauna room, lead
them to the location where the bench sensor is installed, and secure the
bench sensor wires using wire clips.
2. Install the bench sensor on the rear of the cabin using the two included
wood screws
2
(16 mm). The optimum position is opposite the sauna heater.
Maintain a distance of 15 cm to the sauna cabin roof.
ATTENTION!
Sources of interference can have a negative effect on signal transmission
● Lay the heater sensor wires separately from other mains wires and control
wires.
● Protect wires with only one layer of insulation by using a pipe (double insulation).
1
Bench sensor
2
Wood screws (16 mm)
3 Bench sensor wires
2
3
1
Fig. 5