Rev B
Doc 6001564
Page 3 of 19
1. CABINET DIMENSIONS
TYPE OF SYSTEM
HEIGHT
WIDTH
DEPTH
Infinity “L” or “DI”
Surface Mount
21.0”
16 7/16”
4 1/4”
Flush Mount Back Box
21 1/4”
16 3/4”
3 3/16”
Flush Mount Bezel
23 11/16” 19 3/16”
Infinity “M”
Surface Mount
16.0”
11 3/4”
4 1/4”
Flush Mount Back Box
16 7/16”
12 1/4”
3 1/4”
Flush Mount Bezel
18 3/4”
14 1/2”
Infinity “S”
Surface Mount
16.0”
11 3/4”
3 1/4”
Flush Mount Back Box
16 7/16”
12 1/4”
2 1/4”
Flush Mount Bezel
18 3/4”
14 1/2”
Infinity “B:
23.0”
14.0”
2 3/4”
2. WIRE CHART
PLEASE NOTE:
If the wires you are pulling for this installation are going to be run through an indoor,
weather-proof location, it is acceptable to use unshielded cable. If the wires are going to be run through
an outdoor location, we recommend that you use shielded cable. Recommendations for both types of
cable are provided where needed.
A. CABLING TO THE MAIN PROCESSOR BOARD
Cabling to the Main Processor Board
Type
of
Wire
Recommendations
From the power transformer or power supply
2 conductor cable
See chart below:
120 VAC outlet
From the door strike or the door strike
2 conductor cable
See specifications for
power
supply
the
device
you
are
installing.
DC POWER
WIRE SIZE
DISTANCE
AC POWER
WIRE SIZE
18 AWG
30' and under
14 AWG
16 AWG
30'-75'
12 AWG
12 AWG
75'-150'
-----
10 AWG
150'-250'
-----
PLEASE NOTE:
If you are using the larger sizes of cable (i.e., 12 awg or 10 awg), you may experience
problems inserting the wires into the terminal block. If you encounter this problem, you can connect a
16-18 awg wire (with the use of a wire nut) to each end of the power cable, as long as the smaller gage
wire is under 12 inches in length.
