7. INSTALLATIONS
A Sentech heat alarm can be installed in two different ways:
(1) QUICK INSTALLATION WITH 3M DOUBLE-SIDE TAPE
Make sure that the installation surface is even and cleaned thoroughly. If the
ceiling has an uneven surface or rough in texture, install the heat alarm with the
screws supplied.
C) Remove the red cover on the double-sided tape.
D) Attach the heat alarm by pressing it firmly against
the ceiling for approximately 60 seconds. You may
also hear an alarm sound if the test button gets
pressed during installation.
E) Make sure that the heat alarm is activated by
pressing the test button for 3 seconds. When
the heat alarm gives an alarm sound, the test is
complete and your heat alarm is ready for use.
Note: Installation with 3M double-sided tape is not approved according to
Great Britain’s LPCB standard.
The installation is now complete. Test your heat alarm weekly!
The installation is now complete. Test your heat alarm weekly!
(2) INSTALLATION WITH SCREWS
6. PRODUCT COMPONENTS DRAWING
A) Activate the heat alarm by pushing the mounting
plate and turning it clockwise at the same time.
The heat alarm is activated and ready to be
installed when you feel clicks. You may also hear
an alarm sound if the test button gets pressed
during activation.
A) Remove the mounting plate of the heat alarm by
turning it counter-clockwise and lifting it away.
C) Press the heat alarm against the mounting plate
and turn it clockwise until you feel clicks.
D) Make sure that the heat alarm is activated by
pressing the test button for 3 seconds. When
the heat alarm gives an alarm sound, the test is
complete and your heat alarm is ready for use.
B) To achieve the correct heat alarm position, mark
drill holes for the screws then screw the mounting
plate of the heat alarm tightly to the ceiling with
the screws.
B) Remove the white cover on the double-sided tape,
then adhere to the mounting plate.
EN 14604:2005
0832-CPR-F1312
16
1050b/01
