PPD Maintenance Manual
T1DA0502-002, Rev A
Page 12
Figure 4.5 Transmitter Programmer Main Screen
The allowable fields are PPD ID, ARP and Frequency, edit any of these to the desired setting and
select the Program PPD button. If there are no errors a pop-up box will inform you of
programming success. If the PPD has no Pull-pin option ensure that the ARP is set to 0
(disabled). If your frequency of operation is not shown in the list of available choices, consult the
factory.
After programming is successful, the data is read from the PPD to verify settings. Note that if the
PPD has 12 bit modulation firmware, verify the Low Battery ID read from the unit is appropriate
based on your site low battery offset. If not recheck the ini settings and re-start the application.
The following message box may appear after Get Info. This will result for units with an un-
initialized pull-pin ARP setting. Select Yes unless there is a pull-pin inserted and you intend on
immediately adjusting the pull-pin ARP.