Hardware setup
Senstar 100 Installation guide • • • 4 - 3
If you are setting up the hardware on a CU other than node 1,
you MUST specify the CUs node number for the site database
(ranging from 1 to 255). You MUST do this before you set up
the peripheral devices for the CU.
Exiting the Select Hardware menu
1. Press F12.
The
Senstar 100 Startup Program
menu displays.
Selecting the graphics card and number of monitors
You can use the
F1
Select Graphics Card and number of monitors function to
specify the type of graphics card and the number of monitors your Senstar 100
uses.
You can not specify the graphics card or number of monitors
until you have initialized the hard disk (
) and loaded the application software and site data
(
).
1. Press
F1
.
The
Select Graphics Card and Monitors
menu displays.
F1
Select Graphics Card and Number of Monitors
F2
Select and Align Touch Screen
F3
Select Keyboard Type
F4
Set Active Boot Partition
F5
Switch Active VGA Port on WARP Card
F12
Exit Select Hardware
Select Hardware
Press a function key to make a selection
>
VGA MASK 4.03
Version 6.12