Initializing the hard disk
Senstar 100 Installation guide • • • 3 - 7
Set up one partition of at least one 1 Gb for exclusive use by
Senstar 100 applications. For small hard disks (< 10 Gb)
dedicate the entire hard disk for use by the Senstar 100
system. For larger hard disks, edit the partition table so that
the highest cylinder of the QNX partition does not
exceed1023.
Use the
↑
and
↓
arrow keys to select
Y
(yes) or
N
(no) in
response to the onscreen prompts. Press
Enter
to
make the highlighted selection.
4. Press
Enter
to continue the initialization procedure.
5. Press
Enter
to select the default keyboard (English).
6. If the system will use a different type of keyboard during alarm processing
operations, you can specify keyboard type using the Setup hardware function.
For more information about the Setup hardware function, refer to
.
7. Press
Enter
to begin hard disk initialization.
When performing the Initialize Hard Disk function you will
occasionally be prompted to press
Enter
, then press
Enter
again.
You can stop the initialization procedure at any prompt by
pressing
ESC
. However, initialization must be completed once
before any other Startup program function can be used. If you
stop the initialization procedure before it is complete, you must
reboot the computer and begin the procedure again.
Creating a QNX hard disk partition
1. Verify the type of hard disk and its driver by pressing
Enter
.
2. Verify the size of the hard disk by pressing
Enter
.
The
QNX Partition Screen
displays.
Ca
uti
on