Multiple video switchers
Senstar 100 Installation guide • • • b - 5
1. In the
VIDEO SOURCE
section of the CONFIGURE MONITORS menu, enter
the VS in the
DEV
field.
2. Enter the monitor O/P in the
MON
field.
3. Repeat steps 1 and 2 for up to eight monitors per control unit.
Assigning video switcher monitor outputs (manual)
MONITOR TYPE/ID for Manu (Manual) 1 through 4 allows you to define up to
four VS monitor O/Ps used for manually displayed camera views, see
Figure b-4 : Assigning manual video switcher monitor outputs, page b-5
1. In the VIDEO SOURCE section of the
CONFIGURE MONITORS
menu, enter
the VS in the
DEV
field.
2. Enter the monitor O/P in the
MON
field.
3. Repeat steps 1 and 2 for up to four monitors per control unit.
Defining cascaded video switcher signal paths
MONITOR TYPE/ID Casc (Cascade) 1 through 8 allows you to define up to eight
cascaded video signal paths, see
Figure b-5 : Defining cascaded video switcher
Figure b-4: Assigning manual video switcher monitor outputs
CONFIGURE MONITORS
?
Console CU1
MONITOR
TYPE/ID
VIDEO
SOURCE
MON
FRAME/VIDEO SCENE CONTROLLER
TYPE : ATTR
DEV
CARD
PNT
F7
F8
F5
F6
F9
F10
Quit
F1
F2
F3
F4
Page
Page
03/07/04
12:28:32
Manu 1
Source from
VS2
Control
None
0
0
. . .
1
Full
Control
None
0
0
. . .
Full
Manu 2
Source from
VS2
Control
None
0
0
. . .
2
Full
Control
None
0
0
. . .
Full
Manu 3
Source from
---
Control
None
0
0
. . .
0
Full
Control
None
0
0
. . .
Full
Manu 4
Source from
---
Control
None
0
0
. . .
0
Full
Control
None
0
0
. . .
Full
DEV
↓
↓