SENSORWORX SWX-852-B Series, Инструкция по установке и эксплуатации, Страница: 3 / 4

STEP 1
WALL SWITCH OR POWER PACK
STEP 2 & STEP 3
WIRELESS REMOTE SWITCH & DIMMER
STEP 4
WALL SWITCH OR POWER PACK
SWX-851
HOLD
FOR 3 SEC
SWX-950
HOLD
FOR 3 SEC
SWX-854
HOLD
FOR 3 SEC
SWX-852
HOLD
FOR 3 SEC
SWX-851
PRESS ONCE
SWX-950
PRESS ONCE
OR OR
WIRELESS PAIRING
Pairing a remote dimmer/switch with a wireless wall switch load controller or power pack load controller is quickly done via the following procedure:
1. Enter pairing mode by holding down the wireless load controller’s button for 3 seconds until the LED starts alternating white then blue.
2. At the battery powered remote dimmer/switch, hold down the ON button for 3 seconds until the LED starts alternating white then blue. Releasing will pair the device with the
controller in pairing mode (see note 1 below). The lights will toggle once as confirmation.
3. If additional remote dimmers or switches need to be linked, repeat step 2.
4. When all devices have been paired, close pairing mode on the wireless load controller by pressing the button 1 time. Pairing will also be automatically closed after 15 minutes of no
new devices being linked.
Note 1: When in pairing mode, the alternating LED colors on the wireless load controller will periodically pause and blink out the total number of paired devices. There will be no blinks
during the pause until the first device is linked.
CONFIGURATION MISC.
UNPAIRING FROM LINKED LOAD CONTROLLERS
To unpair a wireless remote dimmer or switch from all wirelessly linked load controllers execute the following “ FORGET ME ” procedure.
ENTERING A “FORGET ME” COMMAND
1
Enter programming mode by pressing and holding the
ON
button for at least
6 seconds
until the LED begins flashing
blue only
, then release.
2 Press and release the unit’s pushbutton 8 times , then wait 2 seconds. The White LED will blink back 2 times, pause and repeat.
3 Interrupt the blink back and press the ON button 4 times . The LED will blink back 4 times as confirmation, pause then repeat.
4 Interrupt the confirmation blink back and press and hold the ON button until blue LED changes to white, then release. The LED will then blink white twice as confirmation of success.
Note: To Exit without saving during any step, release button and wait until the unit double flashes blue.