METIS M308 / M309 / M313 / M316 / M318 / M323 / H309 / H316 / H318 (12-pin)
SensorTools Software
33
Scale the graph:
Beginning and end of temperature scale (left) and control out-
put (right) scale can be adjusted to represent the relevant area reasonable.
-
Scale per mouse click:
With the green arrows of the upper and
lower scale range is changed
-
Scale per entry:
The upper and lower temperature can be entered
via the keyboard.
- Scale with mouse drag:
With click, hold and drag on the gray arrows, the
start and end or the entire area can be moved.
- Automatic scale:
automatically adjusts the scale (+10°C above the maxi-
mum value and -10°C below the minimum value):
-
reads out the pyrometers temperature range
-
selects the range from all selected display graphs and always the
highest measured value.
Information field
- M309-7318
in the example on the right shows pyrometer model and serial num-
ber.
-
The
sampling time T-Sample
Shows the time between the last two received
measured values.
-
The
control time T-Contr.
(only devices with PID controller) shows the time a
control process is running already.
-
When the
slope time measurement
is activated, the slope time
T-Slope
shows the time elapsed between the start and the end
temperature. The settings can be found in the "Time measure-
ment" window.
Select display graphs:
Depending on the device type, different graphs can be displayed or hidden; the color can be changed
by right-clicking on a color field.
The transferred measured value data can be
recorded
on hard disk for subsequent analysis.
Click on the recording button to start and stop recording, the button (
) flashes when the re-
cording is active,
Pause interrupts the recording. When recording is active, a red reference text
(create file ...) is displayed above the graphics window.
The amount of data that can be recorded depends on the baud rate (see also
set-
tings
under
Data Collection (Buffer Mode)
).
Note for devices with PID controller:
The recording may be performed together with the controller
start, when the corresponding setting is activated in the
(
) (automatic
recording by: “active control“ as well as “automatic stop of recording by: inactive control“).
The
playback button
opens the
SensorTools
) to display the last measured and,
if necessary, the control values since the device was connected. The amount of measurement data
sets (consisting of the measured temperature, emissivity, device temperature, setpoint, ...) depends
on the
"Maximum data sets in memory".
Scale per
mouse click
Scale with
mouse drag
Scale per
entry
Automatic
scale
Adapt to
pyrometer
’s
temp. range