USER MANUAL
EvaluationTool
STIM202 Evaluation Kit
DOK333 rev.06 21/22 Dec 2017
7.8
Messages from the program
Messages that the program can display are listed in Table 7:
Table 7: Possible messages given by the program
#
Message
Description
1
This application is already running!
Stop loading of 2. instance...
The program is already started, a second instance will
not be allowed
2
Wrong password entered!
The password entered does not match the required one
for this INI-file
3
No response to message was received
Did not receive the expected response to sent service-
mode command
4
There is no measurement data available for storage
To be able to save measurement data, there must be
data available
5
Unable to open the selected file
Saving of measurement data failed, unable to open or
create the selected file
6
Unable to allocate the required memory
Failed to acquire the requested number of datagrams
from the gyro module due to error when trying to allocate
memory for temporary storage
7
No product identification datagram received
Even after retries the, expected datagram is not received
as response to command sent
8
No configuration datagram received
Even after retries the, expected datagram is not received
as response to command sent
9
No serial number datagram received
Even after reties the, expected datagram is not received
as response to command sent
10 No datagrams received
Failed to acquire the requested number of datagrams
from the gyro module, no recognizable datagrams
received
11 Turn off device supply voltage
Instruction to user when running without controlled
power-supply
12 Turn on device supply voltage
Instruction to user when running without controlled
power-supply
13 Error encountered when trying to control voltage
Failed to control the specified power-supply
14 Unexpected DG-ID received !
When waiting for datagrams, unexpected datagrams are
received
15 Unable to read config DG to determine output unit !
Unable to read configuration datagram to determine the
output unit
16 Unable to synch with DG-stream !
Failed to acquire the requested number of datagrams
from the gyro module, unable to get in synch with
datagram stream
17 Error encountered when trying to print, check
configuration !
Failed to print the graph, check that a printer is
configured
18 Unable to create result-folder specified by parameter !
The specified pathname can not be created, either due
to access-rights or errors in the path specification
19 Unable to enter service-mode !
Unable to enter service-mode, does not receive
expected response to command.
20 Unable to save parameters to active INI-file !
Error encountered when trying to save parameters onto
