USER MANUAL
EvaluationTool
STIM202 Evaluation Kit
DOK333 rev.06 20/22 Dec 2017
7.7
Parameters panel descriptions
Table 6: Parameters panel descriptions
Panel unit
Functionality and description
===== General parameters =====
Password
Current valid password to be able to edit the parameters list. The
password is “stim”
Folder for result-file storage
“c:\userdata\test\
What priority will this program run with
Instructs the program priority for the PC operation system
What format to use for result files
ASCII text by default. Can be changed to 8 byte binary
Name of file with language definitions
Application can be configured with language other than English
===== Device communication =====
IMPORTANT MESSAGE: Always verify
hardware connections and COM port settings
before trying to connect to the device
RS422 port # to device 1
Defining which COM port # to be assigned to gyro module (device) #
1
RS422 port # to device 2
Defining which COM port # to be assigned to gyro module (device) #
2
RS422 Bitrate [bit/s]
Manual RS422 bit rate selection. NOTE that USB cable that comes
with the USB kit, supports only the default 460800 bits/s option, while
the PCI card of the PCI kit supports all available bit rates
RS422 Stopbit
1 or 2. Default is “1”
RS422 parity
N
one, odd or even. Default is “None”
===== External Hardware =====
The GPIB Card Number To Use
Normally "0" (when no GPIB card in user). If card(s) are in use; the
first card will be assigned to #1, second to #2, etc. Default value is
“0”
Type Of Power Supply In Use
Normally "None" (when not in use). Agilent E3631A, E3633A and
E3644A supported. Default value is “None”
Interface To Power
Normally "None" (when not in use). RS232 (for Agilent E3631A only)
and
GPIB supported. Default is “None”
Port Or Address To Power
Normally "0", when not in use. Selectable up to 31
. Default is “0”
Voltage On Output Of Power Supply [V]
Default value is “5.1”. Can be neglected if not in use. Value should
be within the supply voltage range of the gyro module. Clicking on
the arrow of the control unit when editing this parameter allows for
voltages as high as 6.0V maximum. Manual entry allows even higher
values, however with a warning. Note: The entered value/ voltage
applied to the gyro module should never exceed the absolute
maximum ratings value for the supply voltage of the gyro module
(maximum 7.0V)
Current Limit On Output Of Power Supply [A]
Default value is “1.0”. To limit the current consumption from the
power source
