© Sensirion Connected Solutions AG, CH
Rev. 0.2
–
D1 - Jun 22
16/21
5
General handling
5.1
Powering up the device
The power connector of the device functions as an on/off switch. To power up the device, simply connect the power
cord from your power source. Please always tighten the union nut to ensure proper protection from water ingress.
5.2
Depowering the device
To power down the device, unscrew the nut and unplug the cable at the device side.
Unplugging the cable will turn off the device and disconnect the battery for transport. After the device has been
depowered, be certain to correctly install
the protective cap to protect the pin’s connector and avoid corrosion or
dirt build-up.
5.3
Storage
The system operates whenever a power plug is connected. Please always disconnect the cable of the power source
from the device as described in section 5.2 when storing it. This procedure ensures that the system is turned off,
avoiding deep discharge of the battery. Only store the device when you are confident that the battery was well
charged.
When storing the device, please always ensure that the protective cap is securely placed on the power connector
to protect the pins and avoid corrosion.