SIGMA S-BEND FLEXIBLE STRIP
Maintenance & Care
• As the LEDs are exposed on this fitting you should not wipe the item or expose it to liquids / cleaning agents.
Sensio, Unit 7, Speedwell Road, Whitwood, Castleford, West Yorkshire, WF10 5PY
www.sensio.co.uk
80 °
Installation
1
2
Measure the length of each area to which the strip is
to be installed.
If the strip is to be cut to length ensure you only cut
along the indicated cut line. These points are every
100mm along the strip so cut at the closest possible
point.
Connect the driver connection cable (SE101080) to
the end of the strip by carefully inserting the strip
and firmly closing the cap. Ensure the + and – points
on the strip and cable match.
3
If you are running the strip around a corner please
ensure that you adhere to the following;
• The angle between the surface and the strip being
pulled should not exceed 20 degrees.
• Minimum bending diameter is 6cm (2.36in).
4
Ensure the surface the strip is being applied to is
clean. Remove the paper protecting the adhesive
on the back of the strip, position the strip carefully
ensuring it is straight and firmly press into place.
Plug the connector on the end of the cable into the
24V LED driver distribution block. Ensure the wattage
of the LED driver is not exceeded. Finally, connect the
driver to the mains supply.
5
6
Accessories
SE101080
2.5M Driver Connection Cable
*This item is required to run the
Sigma flexible strip
SE100750
1.5M Inter-connecting Cable
If more than a single length of Sigma is to be powered, this can be achieved either by connecting the strips
together using either the inter-connecting clip, corner connector or inter-connecting lead (whichever is most
suitable), or by using a driver connection cable on each strip running these back to the driver.
SE100050
End Cap / Inter-connecting clip
Technical drawings are for illustrative purposes only. Sensio has the right to change any information without prior notice.
Make sure you check all hole cut outs before work commences.
Corner Application
